ASTM A641/A641M-19

1.1This specification covers soft, medium, and hard temper zinc-coated (galvanized) carbon steel wire in coils for general use.

1.2The supplementary requirements of this specification cover zinc-coated weights [masses] for nails, staples, and wire from which nails and staples are cut and formed.

1.3This specification is applicable to orders in either inch-pound units (as A641) or SI units (as A641M). Values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in the two systems are not exact equivalents; therefore, each system shall be used independent of the other, without combining values in any way.

1.4This specification and some referenced specifications are expressed in both inch-pound and SI units. If the order specifies the applicable “M” specification designation, the product shall be furnished to SI units.

1.5The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.