Your shopping cart is empty!
ASTM International , 05/01/2018
Publisher: ASTM
File Format: PDF
$24.00$48.00
1.1These test methods cover procedures for testing polytetrafluoroethylene tubing for use as electrical insulation. The procedures appear in the following sections:
Procedure
Sections
ASTM Methods
Conditioning
7
...
Dielectric Breakdown Voltage
28 - 30
D149, D876
Inside Diameter
8 - 13
D876
Mandrel Bend Test
46 - 52
Melting Point
41 - 45
D3418, D4895
Penetration Test
26 and 27
Specific Gravity
36 - 40
D792, D1505
Strain Relief
31 - 35
Volatile Loss
20 - 25
Wall Thickness
14 - 19
Note 1:These test methods are similar but not identical to those in IEC 60684-2.
1.2The values stated in inch-pound units are the standard except for temperature, which is stated in degrees Celsius. Values in parentheses are for information only.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 5.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
$29.00 $58.00
$32.00 $65.00
$25.00 $50.00