ASTM D5890-19

1.1This test method covers an index method that enables the evaluation of swelling properties of a clay mineral in reagent water for estimation of its usefulness in geosynthetic clay liners (GCLs). This test method is not applicable for clays with polymers.

1.2It is adapted from United States Pharmacopeia (USP-NF-XVII) test method for bentonite.

1.3Powdered clay mineral is tested after drying to constant weight at 105 ± 5 °C; granular clay mineral should be ground to 100 % passing a 150-µm (No. 100) U.S. Standard Sieve with a minimum of 65 % passing a 75-µm (No. 200) U.S. Standard Sieve. The bentonite passing the 150-µm U.S. Standard Sieve is used for testing after drying to constant weight at 105 ± 5 °C.

1.4The values stated in SI units are to be regarded as standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 8.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.