• ASTM D6194-18

ASTM D6194-18

Standard Test Method for Glow-Wire Ignition of Materials

ASTM International , 11/01/2018

Publisher: ASTM

File Format: PDF

$34.00$68.00


1.1This test method covers the minimum temperature required to ignite insulating materials using a glowing heat source. In a preliminary fashion, this test method differentiates between the susceptibilities of different materials with respect to their resistance to ignition due to an electrically-heated source.

1.2This test method applies to molded or sheet materials available in thicknesses ranging from 0.25 to 6.4 mm.

1.3This test method is not valid for determining the ignition behavior of complete electrotechnical equipment, since the design of the electrotechnical product influences the heat transfer between adjacent parts.

1.4This test method measures and describes the response or materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. (See IEEE/ASTM SI-10 for further details.)For specific precautionary statements, see Section 9.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 9.

1.7Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

Note 1:Although this test method and IEC 60695-2-13 differ in approach and in detail, data obtained using either are technically equivalent.

1.8This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6194-18 History

ASTM D6194-23

ASTM D6194-23

$28.00 $57.00

ASTM D6194-18

ASTM D6194-18

$34.00 $68.00

ASTM D6194-14

ASTM D6194-14

$29.00 $58.00

ASTM D6194-10

ASTM D6194-10

$30.00 $60.00

ASTM D6194-08

ASTM D6194-08

$30.00 $60.00

More ASTM Standards PDF

ASTM F3084-16

ASTM F3084-16

$32.00 $65.00

ASTM D5324-16

ASTM D5324-16

$38.00 $76.00

ASTM F2870-16

ASTM F2870-16

$30.00 $60.00

ASTM E2948-16a

ASTM E2948-16a

$32.00 $64.00