ASTM D6957-12(2018)

1.1This practice describes the procedure for measuring curl in synthetic filament.

1.2This practice is applicable to filament 2 to 5 in. (50.8 to 127 mm) in length.

1.3This practice is applicable to tapered filament or level filament.

1.4This practice is applicable to loose filling material and material removed from a brush.

1.5The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.