ASTM D6989-03(2020)

1.1These practices describe laboratory procedures for preparing a solvent or water based ink resin solution in low boiling solvent or alkaline water using two types of lab equipment; (1) an industrial blender (Sections 3 - 7), and (2) a laboratory roller mill (Sections 8 - 12).

1.2These practices use laboratory equipment generally available in a normal, well-equipped laboratory.

1.3These procedures are for use with ink resins intended mainly for liquid (for example, flexographic and rotogravure) inks. The type of resins is typically, but not limited to, acrylic and styrene/acrylic copolymers, polyamides, polyesters, polyvinylbutyral, and maleated/fumarated rosin esters.

1.4The typical low boiling solvents to be used include ethanol, isopropanol, n-propanol, ethyl acetate, isopropyl acetate, and n-propyl acetate. For water based ink resin solutions, water is used in combination with ammonium hydroxide or amines such as dimethylethanolamine, monoethanolamine, and triethylamine.

1.5The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.