• ASTM E1486-14

ASTM E1486-14

Standard Test Method for Determining Floor Tolerances Using Waviness, Wheel Path and Levelness Criteria

ASTM International , 04/01/2014

Publisher: ASTM

File Format: PDF

$38.00$76.00


1.1This test method covers data collection and analysis procedures to determine surface flatness and levelness by calculating waviness indices for survey lines and surfaces, elevation differences of defined wheel paths, and levelness indices using SI units.

Note 1-This test method is the companion to inch-pound Test Method E1486.
Note 2-This test method was not developed for, and does not apply to clay or concrete paver units.

1.1.1The purpose of this test method is to provide the user with floor tolerance estimates as follows:

1.1.1.1Local survey line waviness and overall surface waviness indices for floors based on deviations from the midpoints of imaginary chords as they are moved along a floor elevation profile survey line. End points of the chords are always in contact with the surface. The imaginary chords cut through any points in the concrete surface higher than the chords.

1.1.1.2Defined wheel path criteria based on transverse and longitudinal elevation differences, change in elevation difference, and root mean square (RMS) elevation difference.

1.1.1.3Levelness criteria for surfaces characterized by either of the following methods: the conformance of elevation data to the test section elevation data mean; or by the conformance of the RMS slope of each survey line to a specified slope for each survey line.

1.1.2The averages used throughout these calculations are the root mean squares, RMS (that is, the quadratic means). This test method gives equal importance to humps and dips, measured up (+) and down (−), respectively, from the imaginary chords.

1.1.3Appendix X1 is a commentary on this test method. Appendix X2 provides a computer program for waviness index calculations based on this test method.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

More ASTM Standards PDF

ASTM D2726-10

ASTM D2726-10

$26.00 $52.00

ASTM D5966-10

ASTM D5966-10

$33.00 $67.00

ASTM D2103-10

ASTM D2103-10

$30.00 $60.00

ASTM Section 6:2010

ASTM Section 6:2010

$125.00 $251.52