• SAE J429_201304

SAE J429_201304

Mechanical and Material Requirements for Externally Threaded Fasteners

SAE International , 04/29/2013

Publisher: SAE

File Format: PDF

$45.00$90.00


This SAE Standard covers the mechanical and material requirements for inch-series steel bolts, screws, studs, screws for sems , and U-bolts in sizes to 1-1/2 in. inclusive. The term “stud” as referred to herein applies to a cylindrical rod of moderate length threaded on either one or both ends or throughout its entire length. It does not apply to headed, collared, or similar products which are more closely characterized by requirements shown herein for bolts. The mechanical properties included in Table 1 were compiled at an ambient temperature of approximately 20 °C (68 °F). These properties are valid within a temperature range which depends upon the material grade used and thermal and mechanical processing. Other properties such as fatigue behavior, corrosion resistance, impact properties, etc., are beyond the scope of this document and responsibility for ensuring the acceptability of the product for applications where conditions warrant consideration of these other properties shall be borne by the end user.

SAE J429_201304 History

SAE J429_201405

SAE J429_201405

$50.00 $101.00

SAE J 429

SAE J 429

$110.00 $220.68

SAE J429_201304

SAE J429_201304

$45.00 $90.00

SAE J 429

SAE J 429

$120.00 $241.76

SAE J 429

SAE J 429

$138.00 $277.79

More SAE Standards PDF

SAE AIR1872B

SAE AIR1872B

$75.00 $150.00

SAE AMS3814/11

SAE AMS3814/11

$20.00 $41.00

SAE AMS6925A

SAE AMS6925A

$35.00 $70.00

SAE AIR5314

SAE AIR5314

$35.00 $70.00